System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc.C3600 processor with 32768 Kbytes of main memory Main memory is configured to 64 bit mode with parity disabled program load complete, entry point: 0x80008000, size: 0x605798 Self decompressing the image : ############################################################# [OK] Smart Init is enabled smart init is sizing iomem ID MEMORY_REQ TYPE 000037 0X00056400 Combination Single Ethernet 2 WAN 0000A1 0X00020000 Single port HSSI-plus 0X000F3BB0 public buffer pools 0X00211000 public particle pools TOTAL: 0X0037AFB0 If any of the above Memory Requirements are "UNKNOWN", you may be using an unsupported configuration or there is a software problem and system operation may be compromised. Rounded IOMEM up to: 4Mb. Using 12 percent iomem. [4Mb/32Mb] Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco Internetwork Operating System Software IOS (tm) 3600 Software (C3640-I-M), Version 12.2(40a), RELEASE SOFTWARE (fc1) Copyright (c) 1986-2007 by cisco Systems, Inc. Compiled Sat 10-Mar-07 21:57 by pwade Image text-base: 0x60008930, data-base: 0x60A3E000 cisco 3640 (R4700) processor (revision 0x00) with 28672K/4096K bytes of memory. Processor board ID 25198563 R4700 CPU at 100Mhz, Implementation 33, Rev 1.0 Bridging software. X.25 software, Version 3.0.0. 1 Ethernet/IEEE 802.3 interface(s) 2 Serial network interface(s) 1 HSSI network interface(s) DRAM configuration is 64 bits wide with parity disabled. 125K bytes of non-volatile configuration memory. 8192K bytes of processor board System flash (Read/Write) --- System Configuration Dialog --- Would you like to enter the initial configuration dialog? [yes/no]: