þ
System Bootstrap, Version 12.2(7r) [cmong 7r], RELEASE SOFTWARE (fc1)
Copyright (c) 2002 by cisco Systems, Inc.
C2600 platform with 98304 Kbytes of main memory

program load complete, entry point: 0x80008000, size: 0x5942dc
Self decompressing the image : ############################################################################################### [OK]

Smart Init is enabled
smart init is sizing iomem
  ID            MEMORY_REQ                 TYPE
00036A          0X000B3B80 C2610XM Single Fast Ethernet
                0X000F3BB0 public buffer pools
                0X00211000 public particle pools
TOTAL:          0X003B8730

If any of the above Memory Requirements are 
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 4Mb.
Using 4 percent iomem. [4Mb/96Mb]
              Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

           cisco Systems, Inc.
           170 West Tasman Drive
           San Jose, California 95134-1706



Cisco Internetwork Operating System Software 
IOS (tm) C2600 Software (C2600-I-M), Version 12.2(8)T10,  RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Fri 30-May-03 02:45 by kellythw
Image text-base: 0x80008074, data-base: 0x80A2C2B0

cisco 2610XM (MPC860P) processor (revision 0x100) with 94208K/4096K bytes of memory.
Processor board ID JAE074208CP (409723087)
M860 processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)

interface Serial0/0
          ^
% Invalid input detected at '^' marker.

 no ip address
% Incomplete command.

 no fair-queue
     ^
% Invalid input detected at '^' marker.

snmp-server trap-source Serial0/0
                        ^
% Invalid input detected at '^' marker.



Press RETURN to get started!


00:00:07: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
00:00:08: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to down
00:00:09: %SYS-5-CONFIG_I: Configured from memory by consoletdm_eadi_post_configs: TDM Backplane not enabled

00:00:10: %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to administratively down
00:00:12: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software 
IOS (tm) C2600 Software (C2600-I-M), Version 12.2(8)T10,  RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Fri 30-May-03 02:45 by kellythw
00:00:12: %SNMP-5-COLDSTART: SNMP agent on host Router is undergoing a cold start
00:00:12: %IP_SNMP-3-SOCKET: can't open UDP socket
*Mar  1 00:00:12: Unable to open socket on port 161
00:01:12: %IP_SNMP-3-SOCKET: can't open UDP socket
*Mar  1 00:01:11: Unable to open socket on port 161
00:02:12: %IP_SNMP-3-SOCKET: can't open UDP socket
*Mar  1 00:02:11: Unable to open socket on port 161