System Bootstrap, Version 12.0(1)XA4, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
TAC:Home:SW:IOS:Specials for info
Compiled Tue 19-Jan-99 15:47 by linda
MPC860 PowerQUICC, partnum 0x0000, version A03(0x0013)
MC3810 platform with 32768 Kbytes of main memory

program load complete, entry point: 0x23000, size: 0x1582b8
Self decompressing the image : ################################################################################################################################################################# [OK]
Slot 3 OK. Configured as T1 TEB CSU  Serial #14792422 Version 7.00

Initialize Flash file system.....
total size = 8388608 
flashfs[7]: 1 files, 1 directories
flashfs[7]: 0 orphaned files, 0 orphaned directories
flashfs[7]: Total bytes: 8128000
flashfs[7]: Bytes used: 4979712
flashfs[7]: Bytes available: 3148288flashfs[7]: flashfs fsck took 17 seconds.
flashfs[7]: Initialization complete.

%PQUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?
%PARSER-4-BADCFG: Unexpected end of configuration file.

%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.

UART re-init OK (disable AUX port)
program load complete, entry point: 0x23000, size: 0x4b142c
Self decompressing the image : ########################################################################################################################################################################################################################################################################################################################################################################################################################################################################################################################################################################################### [OK]
              Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

           cisco Systems, Inc.
           170 West Tasman Drive
           San Jose, California 95134-1706



Cisco Internetwork Operating System Software 
IOS (tm) MC3810 Software (MC3810-IS-M), Version 12.0(5)XK, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TAC:Home:SW:IOS:Specials for info
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Thu 22-Jul-99 10:55 by linda
Image text-base: 0x00023000, data-base: 0x0091A30C

Slot 3 OK. Configured as T1 TEB CSU  Serial #14792422 Version 7.00
Cisco MC3810 (MPC860) processor (revision 10.01) with 28672K/4096K bytes of memory.
Processor board ID 14791337
PPC860 PowerQUICC, partnum 0x0000, version A03(0x0013)
Channelized E1, Version 1.0.
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
MC3810 SCB board (v16.B0)
1 Multiflex T1(slot 3) RJ45 interface(v02.C0)
1 Six-Slot Analog Voice Module (v07.B0)
1    Analog FXS voice interface (v05.A0) port 1/1
1 3-DSP(slot2) Voice Compression Module(v01.C0)
1 Ethernet/IEEE 802.3 interface(s)
2 Serial(sync/async) network interface(s)
1 Channelized E1/PRI port(s)
1 Channelized T1/PRI port(s)
256K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (AMD29F016) 
Error: could not set value, code = -4



Press RETURN to get started!



Initialize Flash file system.....

total size = 8388608 

../src-m860-mc3810/mc3810_avm.c, 2191, AVM PIM present 
Serial # 201206597 
Version # 8.1 
avm system bus fpga init pass:
:FPGA program OK.  
 avm fpga programming successful 
:avm qslac fpga init pass:
:
00:00:02: 1/1 circuit type voice
00:00:02: 0: started root task

00:00:10: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up
00:00:10: %LINK-3-UPDOWN: Interface Serial1, changed state to down
00:00:10: %LINK-3-UPDOWN: Interface Serial0, changed state to down
00:00:10: %SYS-5-CONFIG: Configured from  by 
00:00:11: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state to up
00:00:11: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1, changed state to down
00:00:11: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to down
00:00:11: %SYS-5-CONFIG: Configured from  by 
00:00:11: %SYS-5-CONFIG_I: Configured from memory by console
00:00:11: %PQUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?
00:00:11: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software 
IOS (tm) MC3810 Software (MC3810-IS-M), Version 12.0(5)XK, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TAC:Home:SW:IOS:Specials for info
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Thu 22-Jul-99 10:55 by linda
00:00:12: %LINEPROTO-5-UPDOWN: Line protocol on Interface Switch0, changed state to up
00:00:12: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up
00:00:13: %LINK-5-CHANGED: Interface Serial1, changed state to administratively down
00:00:13: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state to down
flashfs[8]: 1 files, 1 directories
flashfs[8]: 0 orphaned files, 0 orphaned directories
flashfs[8]: Total bytes: 8128000
flashfs[8]: Bytes used: 4921856
flashfs[8]: Bytes available: 3206144
flashfs[8]: flashfs fsck took 19 seconds.
flashfs[8]: Initialization complete.
00:00:31: %Voice-port 1/1 is up.
00:01:11: %PQUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?